Design and installation of the CGE open charge storage irrigation system See the technical assignment with accompanying documentation (Complex service)
OKPD2 category:
Show all (0 more)
29.32.30.260 Системы вентиляции, отопления и кондиционирования воздуха, их узлы и детали
43 Работы строительные специализированные
43.22.1 Работы по монтажу систем водопровода, канализации, отопления, вентиляции и кондиционирования воздуха
Not applicable. Proposal shall cover the entire lot.
Restriction on submission of a bid higher than previously submitted
Bidding initiator has set a restriction on submission of a bid with a price which is higher than the price of the previous bid submitted by the bidder. Once the bid is submitted, the stated price can not be increased.
:
Yes
Upload of bid-related documents required
Bids not supported with documentation will not be considered.
:
Yes
Auto-extension
If within the last 30 minutes of bid submission period a new bid is submitted, then bid submission deadline will automatically be extended by 30 minutes from the time the last bid is submitted.
:
30 minutes
Payment terms:
The contractor must specify in the TAP the timing of the equipment delivery, the cost of the equipment, the timing of the work and the payment terms.
Delivery terms:
1. EPM-NEZ JSC application, St. Novocherkassk.
2. Grounds for acquisition.
2.1. Federal Law No. 7-FZ of July 13, 2015 "On Environmental Protection".
2.2. Avert excess dust levels in the open CGE charge material warehouse.
3. Products.
Irrigation (dust suppression) system with nozzles along the north and south (long) sides of an open charge store (excluding water cannons).
4. Scope of work carried out.
Design, purchase of materials and equipment, installation.
5. Place of work:
5.1. Design-territory of the Customer and the Contractor.
5.2. Installation on the premises of the current process shop.
6. Specifications:
7. 1Ensure dust suppression throughout the open charge storage area
6.2. Provide for equipment (pump) redundancy during the design.
8. Source data and attached documentation.
8.1. Warehouse dimensions — 120x30 m.
8.1.1. Water connection point - available (near by Ø76mm technical water pipeline, pressure P=2 atm.
8.2. Charm compartment scheme.
Damn 178875 (Appendix #1 TK).
9. Requirements for offers.
9.1. The contractor must specify in the TAP the timing of the equipment delivery, the cost of the equipment, the timing of the work and the payment terms.
9.2. The vendor shall attach a complete set of technical documentation to the offer for approval.
9.2.1. Equipment specifications.
9.2.2. Equipment list.
9.2.3. Installation drawings.
9.2.4. Equipment passports and certificates (nozzles, pumps, pipes and fittings)
9.2.5. Installation instructions.
9.2.6. Instructions for operation.
9.2.7. Maintenance and Repair Instructions.
10. Acceptance of works.
The product is accepted on the territory of the Customer with the signing of the Acceptance Certificate.
11. Warranty period.
The Contractor shall provide the Customer with a warranty of at least 18 months from the date of commissioning.
12. Mandatory requirements and conditions for entering into a contract.
12.1. In the event that the contracting organization's staff (including staffing and number of employees engaged under civil contracts) is less than 10 (10) persons, the contractor's supervisor is required to submit in two copies an appeal containing a roll - call list of personnel before commencing the work under the contract, which is intended to carry out the work under the contract. Copies of civil passports and employment contracts (or civil contracts) signed with the persons in question must be attached to this request.
12.2. As a result of the work under the contract, the contractor, together with the CS-2 Act, provides the customer with copies of the report of the Form NW-M "Information on Insured Persons" and a positive report entry control on the transfer of the report to the territorial authority of the Pension Fund of Russia, signed by the EPC for the period of time specified in the document of Form COP 2 submitted by them.
12.3. In the event of failure to provide the NW-M reports, or if there is a discrepancy less than the number of contractor employees indicated in the previously submitted request, acts KC-2 are not signed by the customer, and the parties to the contract acknowledge that the contractor has not performed the work, and the work is not payable under these acts.
Comments: The participant who participated in the procedure (who made the offer) must upload the following documents to the system before the deadline for applications:
1. Charter (with all additions and changes, if there were any).
2. Certificate of State Registration.
3. Tax Registration Certificate.
4. Extract from the EGRUL.
5. Balance sheet as of the last reporting date with tax authority acceptance mark.
6. Documents confirming the authority of the representative to sign documents:
— Solution (Protocol).
- Power of Attorney.
7. Proposal for work (see Proposal for Work file)
8. Contact: Chesnokov Alexey Leonidovich, tel. 8 (8635) 29-45-30, e-mail: AChesnokov@energoprom.ru
9. ISO 9001:2015 Certificate of Compliance (if available)
This request does not constitute a notice of competition or auction and does not confer any rights to the participants, does not entail any obligations other than those expressly stated in the notice.
10. Executor Requirements:
— Permitting documents (SRO, licences, permits)
— Development of PPR, PPRK, RTI.
— Certification of supervisor, ITR, industrial safety workers at the GOPO.
— Medical clearance of staff to work at the GOPO.
Venue of bidding:
This call for bids is held in electronic form on the e-marketplace of B2B-Center group (www.b2b-center.ru). Bids shall be submitted in the form of e-document.
Контактное лицо:
Контактное лицо: Чесноков Алексей Леонидович, тел. 8(8635)29-45-30, электронная почта: AChesnokov@energoprom.ru
