Carrying out maintenance, repair, adjustment, calibration of digital tachographs with replacement of SCSI units Carrying out maintenance, repair, adjustment, calibration of digital tachographs with replacement of SCSI unitsCollapse
Организатор указал предполагаемую дату подведения итогов. Если в процедуре не будут подведены итоги при наступлении этой даты, то участники могут запросить их самостоятельно
Not applicable. Proposal shall cover the entire lot.
Hide bid prices during bids submission period:
Yes
Upload of bid-related documents required
Bids not supported with documentation will not be considered.
:
Yes
Payment terms:
The Customer pays for the work actually performed no later than 45 calendar days after signing the certificates of work performed and providing
the original invoice;
other terms of payment: the service provider provides a bank guarantee for the advance
payment.
Delivery terms:
The total bid price must cover all obligations of the Bidder to meet the requirements contained in the bidding documentation, including the cost of spare parts and consumables, travel expenses
Comments: Provide the cost of the following works and materials:
Tachograph Atol Drive 5/Smart
Assembly/disassembly of the tachograph
Diagnosis of tachograph
Calibration of the tachograph
Reinstalling the software
Replacing the speed sensor
Replacing the speedometer
Battery replacement
Replacement/installation of the tachograph box
Block SKZI NKM-2/NKM-K
Activation of the NCM unit (SCSI)
Deactivation of the NCM unit (SCSI)
Restoration of the tachograph/components/ work to correct software errors
Replacement of power wiring/speed sensor/speedometer
Digital speedometer
Speed sensor "barrel" (Kamaz, MAZ, PAZ, ZIL, etc.)
Speed sensor "KITAS" (foreign cars)
Tachograph display
Thermal printer
Rear connector (A,B,C,D)tachograph
Cover with racks (the upper part of the tachograph case)
USB connector
USB connector board and K-LINE
The plug of the calibration connector
USB connector plug
Battery
Card reader
Replacing the card reader
Keyboard
Tachograph motherboard
Tachograph interface card
Film keyboard
GSM antenna
GLONASS\GPS antenna
GSM Antenna Replacement
Tachograph mounting frame / box
Cable for additional payment
The cable for the printer
Loop for display
A 30 V Zener diode
Zener diode 47 V
Venue of bidding:
This call for bids is held in electronic form on the e-marketplace of B2B-Center group (www.b2b-center.ru). Bids shall be submitted in the form of e-document.
Контактное лицо:
Всю дополнительную информацию Вы можете получить по телефонам: +7 (47396) 9 63 97;
(специалист отдела тендерных процедур Филиппенко Эльвира Владимировна)
(filippenko_elv@minudo.ru)
